[general] nationalprefix=0 internationalprefix=00 rxgain=0.8 txgain=0.8 language=de ;set default language ;ulaw=yes ;set this, if you live in u-law world instead of a-law ; interface section [ISDN1] ;this example interface gets name 'ISDN1' and may be any ;name not starting with 'g' or 'contr'. ;ntmode=yes ;if isdn card operates in nt mode, set this to yes isdnmode=msn ;'MSN' (point-to-multipoint) or 'DID' (direct inward dial) ;when using NT-mode, 'DID' should be set in any case incomingmsn=* ;allow incoming calls to this list of MSNs/DIDs, * = any ;defaultcid=123 ;set a default caller id to that interface for dial-out, ;this caller id will be used when dial option 'd' is set. controller=1 ;capi controller number to use group=1 ;dialout group ;prefix=0 ;set a prefix to calling number on incoming calls softdtmf=on ;enable/disable software dtmf detection, recommended for AVM cards relaxdtmf=on ;in addition to softdtmf, you can use relaxed dtmf detection accountcode= ;Asterisk accountcode to use in CDRs context=capi-in ;context for incoming calls ;holdtype=hold ;when Asterisk puts the call on hold, ISDN HOLD will be used. If set to 'local' (default value), no hold is done and Asterisk may ;play MOH. ;immediate=yes ;DID: immediate start of pbx with extension 's' if no digits were ;received on incoming call (no destination number yet) ;MSN: start pbx on CONNECT_IND and don't wait for SETUP/SENDING-COMPLETE. ;info like REDIRECTINGNUMBER may be lost, but this is necessary for ;drivers/pbx/telco which does not send SETUP or SENDING-COMPLETE. ;(possible values: 'no', 'yes', 'force', 'g164', 'g165') echocancelold=yes;use facility selector 6 instead of correct 8 (necessary for older eicon drivers) ;echotail=64 ;echo cancel tail setting ;bridge=yes ;native bridging (CAPI line interconnect) if available ;callgroup=1 ;Asterisk call group devices=2 ;number of concurrent calls on this controller (2 make sense for single BRI, 30 for PRI)