Posted: Wed May 20, 2009 2:16 am Post subject: [asterisk-users] "...is circuit-busy" message
Hi,
I am attempting to make about ten calls simultaneously and intermittently
get 'SIP/voipprovider is circuit-busy' followed by 'everyone is
busy/congested at this time"
I am not sure if this is related to my bandwidth to my voip provider, a
configuration issue or something else.
Has anyone seen this before and have any suggestions. Thanks in advance.
Posted: Fri May 22, 2009 6:11 am Post subject: [asterisk-users] "...is circuit-busy" message
Quote:
Hi,
I am attempting to make about ten calls simultaneously and intermittently
get 'SIP/voipprovider is circuit-busy' followed by 'everyone is
busy/congested at this time"
I am not sure if this is related to my bandwidth to my voip provider, a
configuration issue or something else.
Has anyone seen this before and have any suggestions. Thanks in advance.
I have seen this error enough that I know where to look. I would be willing to wager your sip provider is not properly registered or your outbound trunk is not properly configured. The first thing I do is 'sip show peers' and 'sip show registry' to look for registration failures. If that fails then core set verbose 20 and make a couple of calls. If everything looks right except for the 'all circuits busy' then what you see below. Hope this helps!
[root@localhost ~]# asterisk -r
localhost*CLI> sip show peers
Name/username Host Dyn Nat ACL Port Status
from-callcentric/1777XXXX 204.11.192.22 5080 OK (107 ms)
7 sip peers [Monitored: 6 online, 1 offline Unmonitored: 0 online, 0 offline]
localhost*CLI> sip set debug ip 204.11.192.22
localhost*CLI> sip set debug off
SIP Debugging Disabled
localhost*CLI>
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum